|
Release 2.0 |
Adds support for TCP/IP Line Printer
Daemon Protocol, RFC 1179. |
| |
Adds support for a direct TCP/IP
connection "Open Sockets Interface". |
| |
Adds option to process setup codes for
XEROX type printers. |
| |
Adds menu system to better control the
resources defined to PQP. |
|
Allows size of the letters used on the separator page to be
determined by the PCL portrait and landscape setup codes. |
|
Adds option to the RESTART command to allow all reports in a failed
status to be restarted for a printer. |
|
Adds option to set the Characters Per Inch (CPI) for SCS type
printers. |
|
Adds option to set the Maximum Print Position (MPP) to the WIDTH
value specified in the Destination entry for SCS type printers. |
|
Expands PQP buffer pools automatically. |
| |
Adds new option to RESTART a report from
any page in the report. |
|
Download Power Queue for Printers 2.0
upgrade |
|
|
Release 1.3 |
Optional feature to send the report to
the printer without any formatting has been added. Reference the RAW
and TRT parameters in the Destination Table (JQPFDFDS). |
| |
Current operating system information is
displayed upon startup including the lpar, cpuid and model. |
| |
An "intervention required" message is
displayed on the console when JQP waits for more than 60 seconds for
a printer I/O to complete. |
| |
Performance enhancement for SCS type
printer by using exception response mode rather than definite
response mode. |
| |
Optional feature to set the Maximum
number of Lines per Page (MPL) and Lines Per Inch (LPI) from the
information found in the FCB image. Reference the SETUP parameter in
the Destination Table (JQPFDFDS). |
|
|
Release 1.2 |
Optional output class parameter has been
added to the report selection process. |
| |
On the LIBRARYP display, the MOUNT
command can be issued for a printer by keying the form to be mounted
in the command line, placing the cursor on the line of the printer
and pressing the PFkey equated to the command. |
| |
Support to print multiple copies of the
report has been added. |
|
|
Release 1.1 |
The JQPFDFCT control table parameter
SCANINT was added to allow the time PQP waits before scanning the
VSE/POWER LST queue for reports to be printed to be changed to the
installations requirements. |
| |
Priority of the print request in the
Print Work Queue is initially set based on the priority of the
report in the VSE/POWER LST queue when the report was selected. A
new command, PRIORITY, has been added to change the priority of the
print request after it has been selected for printing. |
| |
LIBRARYQ command has been enhanced to
allow a second optional parameter to limit the display based on
jobname. |
| |
PURGE command has been enhanced to allow
a second optional parameter to purge print request from the Print
Work Queue based on printer. A third optional parameter was added to
purge print requests from the Print Work Queue based on the jobname. |
| |
On LIBRARYQ displays, the PURGE, HALT
and RESTART commands can be issued for a print request entry by
placing the cursor on the line of the print request to be purged,
halted, or restarted and pressing the PFKey equated to the command. |
| |
On LIBRARYP displays, the START and STOP
commands can be issued for a printer by placing the cursor on the
line of the printer to be started or stopped and pressing the PFKey
equated to the command. |
